EO-79
QB50P1 · amateur radio satellite, NORAD 40025
Not heard todayNew to satellites? Read how to make your first contact.
Doppler plan for a handheld
A handheld tunes in 5 kHz steps: load these channels, and switch to the next one at the time shown.
Times are local. The file is CHIRP's generic CSV: open it there and copy the memories to your radio.
Chat room for EO-79
Chat with other operators on a EO-79 pass to arrange a contact. The room is open around the passes over your station.
EO-79 frequencies
| Uplink | Downlink | Beacon | Mode |
|---|---|---|---|
| 435.047-435.077 MHz | 145.935-145.965 MHz | — | USB linear inverting |
| — | 145.815 MHz | — | BPSK 1k2 |
| — | 145.8137 MHz | — | BPSK 1k2 |
| — | — | 145.880 MHz | CW 15 bd |
Nominal frequencies, without Doppler. The live map shifts them for your station during a pass. Frequencies: SatNOGS DB (modified: working amateur transmitters only, in MHz), CC BY-SA 4.0.
Radio control (CAT)
Radio control needs desktop Chrome, Edge or Firefox 151+
Experimental. CAT control is new and tested on few radios. It only tunes the receive frequency and never keys the transmitter. Found a bug? Tell us via the feedback form.
Not connected.
Setup help
- In the radio's menu set #020 [CAT/LIN/TUN] to CAT, and #019 [CAT RATE] to the baud rate chosen above (4800 is the factory setting). These are the FT-897 menu numbers; on an FT-817 CAT RATE is menu #14, on an FT-857 look for CAT RATE in the menu.
- Connect a USB serial cable (FTDI or CP210x) to the radio's CAT jack. On a Mac, pick the port named cu.usbserial-… in the list. Close other programs that use the port (WSJT-X, fldigi, a CAT program).
- Receive only: the page changes the receive frequency and never keys the transmitter. Tune the radio to the downlink in the mode the signal uses, with split off. The page then follows Doppler, and follows your knob when you tune around.
- It needs desktop Chrome or Edge, or Firefox 151+, and a station location set above.
About EO-79
EO-79 (European-OSCAR 79) is QB50p1, one of two 2U precursor CubeSats for the QB50 project, a planned network of 50 university CubeSats to study the lower thermosphere. It was built on an ISIS platform for the von Karman Institute in Belgium and launched on 19 June 2014 on a Dnepr rocket from Yasny, Russia. Its science payload was an ion and neutral mass spectrometer.
QB50p1 also carried FUNcube-3, a linear transponder from AMSAT-NL. In November 2016, after the science mission was over, AMSAT-UK and AMSAT-NL put it into regular amateur service: uplink 435.047–435.077 MHz LSB, downlink 145.935–145.965 MHz USB, about 400 mW. It is an inverting transponder with the uplink on 70 cm, so most of the Doppler correction is on your transmit frequency. Because of the power budget it ran only about 25 minutes per orbit, starting 27 minutes after the satellite came into sunlight.
AMSAT's list of inoperative satellites (February 2026) gives EO-79 as non-operational.
Status
Listed as working, but nobody reported hearing EO-79 on AMSAT in the last 30 days.
From reports filed on AMSAT, last 30 days.
Orbit
| Type | Low Earth orbit |
|---|---|
| Altitude | 498–512 km |
| Inclination | 98.1° |
| Period | 94.7 min |
| TLE epoch | 2026-11-20 07:23 UTC |
Orbital elements: CelesTrak (AMSAT and SatNOGS for satellites CelesTrak lacks), checked every 3 hours.
Questions about EO-79
- What is the EO-79 uplink frequency?
- EO-79 listens on 435.047-435.077 MHz (USB linear inverting).
- What is the EO-79 downlink frequency?
- EO-79 transmits on 145.935-145.965 MHz (USB linear inverting), 145.815 MHz (BPSK 1k2) and 145.8137 MHz (BPSK 1k2).
- What is the EO-79 beacon frequency?
- The beacon is on 145.880 MHz.
- Is EO-79 active?
- Listed as working, but nobody reported hearing EO-79 on AMSAT in the last 30 days.
- When does EO-79 pass over my location?
- Open EO-79 on the live map and enter your Maidenhead locator or use GPS: the tracker lists the passes of the next 24 hours with AOS, maximum elevation and LOS, and shifts the frequencies for Doppler.