CO-58
CUBESAT XI-V · amateur radio satellite, NORAD 28895
Not heard todayNew to satellites? Read how to make your first contact.
Doppler plan for a handheld
A handheld tunes in 5 kHz steps: load these channels, and switch to the next one at the time shown.
Times are local. The file is CHIRP's generic CSV: open it there and copy the memories to your radio.
Chat room for CO-58
Chat with other operators on a CO-58 pass to arrange a contact. The room is open around the passes over your station.
CO-58 frequencies
| Uplink | Downlink | Beacon | Mode |
|---|---|---|---|
| — | — | 437.4631 MHz | CW |
Nominal frequencies, without Doppler. The live map shifts them for your station during a pass. Frequencies: SatNOGS DB (modified: working amateur transmitters only, in MHz), CC BY-SA 4.0.
Radio control (CAT)
Radio control needs desktop Chrome, Edge or Firefox 151+
Experimental. CAT control is new and tested on few radios. It only tunes the receive frequency and never keys the transmitter. Found a bug? Tell us via the feedback form.
Not connected.
Setup help
- In the radio's menu set #020 [CAT/LIN/TUN] to CAT, and #019 [CAT RATE] to the baud rate chosen above (4800 is the factory setting). These are the FT-897 menu numbers; on an FT-817 CAT RATE is menu #14, on an FT-857 look for CAT RATE in the menu.
- Connect a USB serial cable (FTDI or CP210x) to the radio's CAT jack. On a Mac, pick the port named cu.usbserial-… in the list. Close other programs that use the port (WSJT-X, fldigi, a CAT program).
- Receive only: the page changes the receive frequency and never keys the transmitter. Tune the radio to the downlink in the mode the signal uses, with split off. The page then follows Doppler, and follows your knob when you tune around.
- It needs desktop Chrome or Edge, or Firefox 151+, and a station location set above.
About CO-58
CO-58 (CubeSat-OSCAR 58), launched as CubeSat XI-V, is a 1U CubeSat of the Intelligent Space Systems Laboratory at the University of Tokyo. "XI" stands for "X-factor Investigator", a name inspired by its cube shape. XI-V was built as the backup of XI-IV (CO-57), one of the first CubeSats ever launched in 2003.
XI-V went up on 27 October 2005 on a Kosmos-3M rocket from Plesetsk, together with the European student satellite SSETI Express, the German UWE-1 CubeSat and the British TopSat. Like its twin, it was built to test commercial off-the-shelf parts in space. It carries an 800 mW transmitter for 1200 baud AFSK AX.25 packets on 437.345 MHz and an 80 mW CW beacon on 437.465 MHz, under the callsign JQ1YGW.
The XI project aimed to cut the cost of small satellites by using commercial components and to build up a database of how those parts behave in space.
Status
Listed as working, but nobody reported hearing CO-58 on AMSAT in the last 30 days.
From reports filed on AMSAT, last 30 days.
Orbit
| Type | Low Earth orbit |
|---|---|
| Altitude | 641–662 km |
| Inclination | 98.3° |
| Period | 97.8 min |
| TLE epoch | 2026-11-19 21:55 UTC |
Orbital elements: CelesTrak (AMSAT and SatNOGS for satellites CelesTrak lacks), checked every 3 hours.
Questions about CO-58
- What is the CO-58 beacon frequency?
- The beacon is on 437.4631 MHz.
- Is CO-58 active?
- Listed as working, but nobody reported hearing CO-58 on AMSAT in the last 30 days.
- When does CO-58 pass over my location?
- Open CO-58 on the live map and enter your Maidenhead locator or use GPS: the tracker lists the passes of the next 24 hours with AOS, maximum elevation and LOS, and shifts the frequencies for Doppler.