CAS-2T
CAS-2T & KS-1Q · amateur radio satellite, NORAD 41847
Heard todayNew to satellites? Read how to make your first contact.
Doppler plan for a handheld
A handheld tunes in 5 kHz steps: load these channels, and switch to the next one at the time shown.
Times are local. The file is CHIRP's generic CSV: open it there and copy the memories to your radio.
Chat room for CAS-2T
Chat with other operators on a CAS-2T pass to arrange a contact. The room is open around the passes over your station.
CAS-2T frequencies
| Uplink | Downlink | Beacon | Mode |
|---|---|---|---|
| — | 435.710 MHz | — | CW 14 bd |
Nominal frequencies, without Doppler. The live map shifts them for your station during a pass. Frequencies: SatNOGS DB (modified: working amateur transmitters only, in MHz), CC BY-SA 4.0.
Radio control (CAT)
Radio control needs desktop Chrome, Edge or Firefox 151+
Experimental. CAT control is new and tested on few radios. It only tunes the receive frequency and never keys the transmitter. Found a bug? Tell us via the feedback form.
Not connected.
Setup help
- In the radio's menu set #020 [CAT/LIN/TUN] to CAT, and #019 [CAT RATE] to the baud rate chosen above (4800 is the factory setting). These are the FT-897 menu numbers; on an FT-817 CAT RATE is menu #14, on an FT-857 look for CAT RATE in the menu.
- Connect a USB serial cable (FTDI or CP210x) to the radio's CAT jack. On a Mac, pick the port named cu.usbserial-… in the list. Close other programs that use the port (WSJT-X, fldigi, a CAT program).
- Receive only: the page changes the receive frequency and never keys the transmitter. Tune the radio to the downlink in the mode the signal uses, with split off. The page then follows Doppler, and follows your knob when you tune around.
- It needs desktop Chrome or Edge, or Firefox 151+, and a station location set above.
About CAS-2T
CAS-2T is a 2U CubeSat of CAMSAT, the Chinese amateur satellite group, built as a technical test for its CAS-2 series of amateur satellites with secondary school pupils from Beijing's Fengtai, Xicheng and Haidian districts. It was launched on 9 November 2016 on the second flight of the Long March 11 rocket from Jiuquan. CAS-2T and a second small payload, KS-1Q of the Kechuang Aerospace Forum, were designed to stay attached to the rocket's upper stage, which is why the catalogue lists them as one object.
The upper stage was expected to re-enter within about a month, but it reached an orbit of about 500 by 1,000 km and has stayed up for years. CAS-2T carried a CW telemetry beacon on 435.710 MHz and an FM transponder with its uplink on 145.925 MHz and downlink on 435.615 MHz; early measurements by radio amateurs suggested that the transponder was not fully working. KS-1Q transmitted 20 kbps GMSK telemetry on 436.500 MHz.
Status
Active: amateurs reported hearing CAS-2T on AMSAT 6 h ago.
From reports filed on AMSAT, last 30 days.
Orbit
| Type | Low Earth orbit |
|---|---|
| Altitude | 499–985 km |
| Inclination | 98.4° |
| Period | 99.7 min |
| TLE epoch | 2026-11-20 04:42 UTC |
Orbital elements: CelesTrak (AMSAT and SatNOGS for satellites CelesTrak lacks), checked every 3 hours.
Questions about CAS-2T
- What is the CAS-2T downlink frequency?
- CAS-2T transmits on 435.710 MHz (CW 14 bd).
- Is CAS-2T active?
- Active: amateurs reported hearing CAS-2T on AMSAT 6 h ago.
- When does CAS-2T pass over my location?
- Open CAS-2T on the live map and enter your Maidenhead locator or use GPS: the tracker lists the passes of the next 24 hours with AOS, maximum elevation and LOS, and shifts the frequencies for Doppler.