Receiving Meteor-M LRPT weather images
Meteor-M2-3 and Meteor-M2-4 send weather images on 137 MHz. A V-dipole, an RTL-SDR-class receiver and SatDump are enough to decode them. The satellites are not amateur ones, so this is receive only.
Which Meteor is on the air
The operator has moved the LRPT signal between 137.1 and 137.9 MHz and between 72k and 80k symbol rates, without notice (see the Meteor-M status log). The table lists the downlinks that SatNOGS DB has as working. It can show more than one, so check the latest observations on SatNOGS DB to see which one is on the air today.
| Satellite | NORAD | Downlink |
|---|---|---|
| METEOR-M2 3 | 57166 |
137.9125 MHz LRPT 80k 137.900 MHz LRPT 72k 137.100 MHz LRPT 72k 137.100 MHz LRPT 80k 137.900 MHz LRPT 80k |
| METEOR-M2 4 | 59051 |
137.9125 MHz LRPT 80k 137.900 MHz LRPT 80k 137.100 MHz LRPT 80k 1705.000 MHz HRPT 3000k 1700.000 MHz HRPT 3000k 137.100 MHz LRPT 72k 137.900 MHz LRPT 72k |
Frequencies: SatNOGS DB (modified: working transmitters only, in MHz), CC BY-SA 4.0.
Next passes
The live map with both Meteors selected shows their passes for your station. Each satellite page has a table of its next passes: METEOR-M2 3, METEOR-M2 4.
Antenna and receiver
The simplest antenna is a horizontal V-dipole. Each arm is a quarter wave: 54.5 cm in free space at 137.5 MHz, cut a few percent shorter in practice. Spread the arms 120 degrees apart. Mount it outdoors, horizontal, with the V opening along the north-south line, because the satellites fly north-south. The signal is circularly polarised, so a linear dipole loses about 3 dB, but a horizontal one also cuts vertically polarised ground signals by about 20 dB, which a QFH or a turnstile does not do. The RTL-SDR Blog write-up has the details. A QFH or a turnstile works as well.
Any RTL-SDR-class receiver will do. A low-noise amplifier at the antenna helps if the cable is long. If broadcast FM overloads the receiver, put a broadcast-FM notch filter in front of it.
Decoding with SatDump
SatDump has a pipeline for each rate: METEOR M2-x LRPT 72k and METEOR M2-x LRPT 80k. Both are OQPSK, at 72000 and 80000 symbols per second. The pipelines start at 137.9 MHz as primary and 137.1 MHz as backup, and use a 1 Msps sample rate by default, which an RTL-SDR can do. Pick the pipeline that matches what the satellite sends now. If you record the baseband during the pass, you can run both pipelines on the same file afterwards (see the SatDump Meteor pipelines).
No sync or no image
- Wrong frequency. The satellite may have moved between 137.1 and 137.9 MHz. Try the other one.
- Wrong symbol rate. Run the 80k pipeline if 72k does not lock, and the other way round.
- Low pass. A pass that peaks at a few degrees is mostly trees, houses and noise. Pick a pass with a high maximum elevation.
- FM broadcast overload. Strong broadcast stations near 88–108 MHz swamp a cheap dongle and the whole band looks noisy. Add a broadcast-FM notch filter.
- Antenna. Keep the dipole horizontal and the arms at 120 degrees, with a clear view of the sky.
- Gain too high. Lower the gain until the noise floor stops rising.
- Doppler and dongle offset. The Doppler shift at 137 MHz is about ±3 kHz (computed from the orbital speed of about 7.4 km/s). A cheap dongle with a wrong ppm correction adds to it, so set the correction.
- Satellite off. The LRPT transmitter is sometimes switched off. Look at the recent SatNOGS DB observations before you change the setup.
Questions
- What is the frequency of Meteor-M2-3 and Meteor-M2-4?
- Both send LRPT on 137.1 or 137.9 MHz. The operator switches between them without notice, so take the current one from the table on this page or from recent observations in SatNOGS DB. SatDump lists 137.9 MHz as primary and 137.1 MHz as backup.
- Do I need a dish or an amplifier to receive Meteor-M?
- No dish. A V-dipole, turnstile or QFH antenna for 137 MHz and an RTL-SDR or a similar SDR are enough. A low-noise amplifier helps with a long cable.
- Should I decode Meteor-M as 72k or 80k?
- SatDump has a pipeline for each: METEOR M2-x LRPT 72k and METEOR M2-x LRPT 80k. The satellites have used both, so if one pipeline does not sync, try the other.
- Why does SatDump show no sync on a Meteor pass?
- The usual causes are the wrong frequency or symbol rate, a pass that stays low, FM broadcast overload, too much gain and a satellite that is switched off. The checklist on this page goes through them.